Industrial air conditioning maintenance is an issue that many people, many businesses care about when the hot season starts, so how to maintain it to ensure it does not harm things and still be effective.
This time the signs of the hot summer are getting more and more clear, as the high internal temperatures are also when industrial air conditioners become essential. After a long period of “hibernation” of no use, many people question the direct use of the air-conditioning system – valuable equipment and irreplaceable effects in the summer. Therefore, users need to start and check the operating status of the machine and carry out maintenance work.
Industrial air conditioning maintenance like?
When the air conditioner is turned on when the air conditioner is turned on, there is a bad smell because it has not been used for a long time, so there is mold in the indoor unit. The machine runs about a little bit, it will get rid of the bad smell, if not all the odors need to be removed and cleaned again because the smell of mold is not good for health.
If when using the toilet, the user feels that the toilet smells, the cause may be that the indoor drain hose connects directly to the toilet drain system or gas pit without steam traps, the odor in The exhaust pipe or gas hole goes back into the indoor unit causing foul.
In case there is a bad smell of gas: In this case, it may be caused by a leak of gas in the indoor unit, so turn off the engine and open the door and exhaust fan for ventilation, cold gas at a high concentration will cause shock or unconsciousness if inhaled.
The indoor unit is melted, the casing is dewy, the wind blows out in the form of mist or blows out water drops, the indoor unit is frozen, and can be handled in the following ways:
If the indoor unit has a lot of water leaks because the drain hose is blocked or chipped, if the indoor unit blows out a drop of water, the indoor unit may be too dirty. In some cases due to manufacturer error, these indoor units have some gaps that are too large so the fan sucks out the water droplets.
When the indoor unit is frozen, it is because the indoor fan is not rotating or rotating slowly. Should repair the fan immediately, otherwise it could lead to compressor damage (block).
Also in the case the machine is not cold or cold or not, there are many reasons to check: Adjust the operating mode on the wrong remote: check on the remote to set the correct mode (mode) Cool or Auto, if not, correct it. Dry, Fan, Heat modes are not cooled. In some cases the Timer may not be cold. Should carefully read the instruction manual supplied with the machine in order to use the device properly.
If the air conditioner has gas leak: check very easily by observing 2 copper pipes connected to the outdoor unit, both small and large pipes are not wet, touching is not cold (when the air conditioner works well, both Both have approximately the same temperature of about 5-7 degrees Celsius, two pipes are wet with eye), the wind blowing out of the outdoor unit is not hot.
Next summer, we need to pay attention to moderate temperature adjustment, the larger the temperature difference compared to the environment, the more electricity consumption. Adjust the temperature according to the ability of each person to adapt. In addition, the temperature difference is too large, it is not good for your health.
One clever use is to adjust the temperature in the room not much difference from the outside temperature. And around 4 o’clock should change the temperature in the room by opening the door to let in natural air.
Leave a Reply